16
SECTION 35 − HYDRAULIC SYSTEM − CHAPTER 1
603.54.471.00 − 11 − 2004
REMOVAL − REFITTING − OVERHAUL OF REAR MECHANICAL HYDRAULIC LIFT ASSEMBLY
REAR HYDRAULIC LIFT ASSEMBLY
Removal−Refitting (Op. 35 110 30)
To remove the hydraulic lift assembly from the rear
transmission casing, proceed as follows.
DANGER
Lift and handle all heavy parts using suitable lifting
equipment with sufficient hoisting capacity.
Check that the assemblies or parts are held firmly
and supported by suitable slings and hooks. Make
sure nobody is standing near to the load.
1. Disconnect the negative cable (1) from the
battery.
8
1
TRE0035A
2. Remove the top link (1).
9
1
TRE0112A
To Next Page
Loading...
