25
SECTION 10 − ENGINE − CHAPTER 1
603.54.471.00 − 11 − 2004
TOOLS
WARNING: The operations described in this section
can only be carried out with the ESSENTIAL tools
indicated by an (X).
To work safely and efficiently and obtain the best
results, it is also necessary to use the recommended
specific tools listed below and certain other tools
which are to be made according to the drawings
included in this manual.
List of specific tools required for the various
operations described in this section.
X 380000236 Tractor dismantling stand.
380000216 Engine lifting hook.
380000301 Rotating engine service stand.
380000313 Engine mounting brackets for rotat-
ing stand 380000301.
X 380000303 Compression test kit (complete with
dummy injector 380000617.
291966 Digital rev counter.
291979 Digital temperature gauge.
380000240 Engine oil pressure test kit.
293240 Check set, turbocharger
(TD95D model).
293679 Filter cartridge removal tool
X 296118 Drive belt tension test tool.
X 291160 Piston ring pliers.
X 291048 Piston ring clamp.
X 292248 Protractor for angular torque
measurement.
X 291504 Puller for crankshaft pulley hub.
X 380000232 Wrench for valve clearance adjust-
ment.
X 380000219 Punch for valve guide extraction /
installation.
X 380000276 Twist bit for enlarging valve guide
bore.
X 380000277 Tapered grinder for exhaust valve
guides.
X 380000242 Bush for valve guide installation
(with 380000219).
X 380000222 Valve guide reamer.
X 380000302 Valve spring compressor.
X 380000246 Set of grinding tools for regrinding
injector seat.
X 380000223 Puller for coolant pump impeller.
X 380000247 Drift for installation of coolant pump
impeller seal.
380000311 Wrench for injection pump delivery
line unions.
380000254 Injector cleaning kit.
380000308 Injector splitting support.
X 380000309 Wrench set for injector dismantling.
380000310 Injection check hand pump.
380000215 Hand pump for injector calibration
test.
293830 Adaptor for injector removal (with
380000549).
380000549 Slide hammer.
Injection pump bench test
380000228 Dial gauge (1/100 mm (0.0394/
3.94 in.) scale, 5 mm (0.1968 in.)
stroke, ∅ 40 mm (1.5748 in.) with
380000229).
380000229 Device for BOSCH injection pump
timing on engine.
X 380000322 Extractor for injection pump drive
gear.
To Next Page
Loading...
