New Holland TD60D - Adjusting LIFT−O−MATIC Device

35
SECTION 35 − HYDRAULIC SYSTEM − CHAPTER 1
603.54.471.00 − 11 − 2004
69
8. Move the draft control lever (2) to a distance (L
2
)
of 105 − 115 mm (4.1338 − 4.5275 in.) from the
beginning of the slot and check that at this
position the arms start to rise.
9. If they do not, adjust the eccentric pin (1) fig. 60,
to restore this distance.
10. Fasten the eccentric pin using the securing bolt
(1) fig. 61.
L2
1
2
TRE0109A
Adjusting LIFT−O−MATIC device
Proceed as follows:
11. Move the position control lever (1) and the draft
control lever (2) fully forward in the sector.
70
TRE0116A
1
2
71
12. Raise the lift arms by means of the lever (1).
1
2
TRE0017A
72
13. Tighten the nut (1) fig. 72, until the arms lower.
14. With the lever (1) fig. 71, still in the same
position, unscrew the nut (1) fig. 72, until the
arms begin to rise.
15. Unscrew the nut (1) by another 1.5 turns.
16. Using the levers (1) and (2) fig. 71, lower and
raise the arms a few times to ensure that the
system is operating correctly.
1
TRE0117A