28
6 SPEED functions
6.1 SPEED main-function
Boat speed through the water.
Unit available in knots (KT), km/h (Kh) or miles/h (Mh) (See
12.1.2,C11). If a navigator is connected, speed over ground
(SOG) can be displayed. (See 12.1,C11 and C13).
6.2 SPEED sub-functions
6.2.1 TRIP LOG (TRP)
0-199,99 NM, only displayed in NM. Distance covered from power
on.
To reset TRIP LOG press DOWN and UP together.
6.2.2 TOTAL LOG (LOG)
0-19999 NM, only displayed in NM. Can not be reset.
6.2.3 START TIMER (STA)
Count down timer from 10 and 5 minutes.
To start the timer from minus 10 minutes (-10’STA) press KEY.
To start the timer from minus 5 minutes (-5’STA), press KEY
again.
When started, displays the count down time in minutes and
seconds.
During the last 10 seconds the alarm will sound once every
second.
6.2.4 TIMER
Elapsed time in hr/min/sec from power on, or from end of start
timer count down. To reset, press DOWN and UP together.
6.2.5 DISTANCE (DST)
Covered distance from power on, or from reset of timer. To reset,
press DOWN and UP together.
6.2.6 AVERAGE SPEED (AVS)
Average speed from power on, or from reset of timer. To reset press
DOWN and UP together.
6.2.7 DAMPING (SEA)
Damping of indicated boat speed through the water. Controls the
response time of speed changes.
To change damping, press KEY.
To select damping level, press UP and select from:
(LOW) 1 sec, (MID) 5 sec and (MAX) 22 sec.
To store the value, press KEY.
SPEED FUNCTIONS
To Next Page
Loading...
