46
Select sub-function (Goto 1), press KEY.
To select leg (*3), press DOWN, 2 times.
To insert the waypoint before leg (*3), press UP and KEY together.
The text (In-SErt) will be displayed with the previous Goto NXT
waypoint flashing.
To select waypoint number (04), press MODE then UP 1 time.
To store the inserted waypoint (04), press KEY.
Bearing and distance from the previous waypoint (02) to the
inserted waypoint (04) will be displayed as the new leg *(3).
To exit from the function, press MODE.
The new sail plan will look like this:
Leg (*1) Go FROM (00) Goto NXT (01)
Leg (*2) Go FROM (01) Goto NXT (02)
Leg (*3) Go FROM (02) Goto NXT (04)
Leg (*4) Go FROM (04) Goto NXT (03)
Leg (*5) Go FROM (03) Goto NXT (04)
The last inserted waypoint will move down all the following
waypoints one step in the sailplan. If the sailplan is already
contains 24 waypoints (full), and you add or insert a new
waypoint, the 24:th waypoint will be automatically cancelled from
the sailplan.
8.6 Arrival alarm
If the function (Goto WP) has been activated, the audible and
visual arrival alarm is triggered automatically, when the boat
arrives within a selected radius from the (Goto WP) waypoint.
Factory setting radius value is 0.10 nautical mile. (See 12.3.12,
C41).
When the audible alarm is triggered (beeps 3 times), the text
(ArriVAL) flashes 3 times on all connected Multi Control
instruments. After the arrival alarm the instrument will revert to the
previous displayed function.
To turn off arrival alarm set C41 to (0.00 ARC). (See 12.3.12).
NAVIGATION FUNCTIONS
To Next Page
Loading...
