42
If the longitude is more than 99° East or West the cursor for the
100:th digit flashes. If the 100:th digit is not displayed, press UP to
activate it.
To enter the new longitude co-ordinates, and to select hemisphere
East (E) or West (W), press MODE, DOWN and UP as required.
Press KEY to store the longitude.
The last edited (Ed) waypoint number is displayed together with
the alternating latitude and longitude co-ordinates.
If you want to edit another waypoint number, press DOWN or UP
to select the waypoint number, then press KEY and re-start the
above procedure.
To exit from the function (Edit WP), press MODE.
The (Goto WP) function will be selected automatically. This is
because it is most likely you would like to select one or more of
the edited waypoints to be used for navigation in the (Goto WP)
function sailplan.
To return to the function (Edit WP), press UP.
To create a sailplan (Goto WP), (see 8.5).
8.4.3 Cancel a waypoint
Select sub-function (Edit WP), press KEY.
The last edited (Ed) waypoint number is displayed.
To select the waypoint number to be cancelled, press DOWN or
UP.
To cancel the waypoint, press DOWN and UP together.
The latitude and longitude co-ordinates will be replaced by the text
(FREE).
To exit the function (Edit WP), press MODE.
8.5 Create a sailplan (Goto WP)
The Server contains a memory for 1 sailplan that can store up to
24 waypoints.
Each part of the sailplan is called a leg. A leg consists of 1 go
from (Go FROM) waypoint and 1 go to next (Goto NXT) waypoint.
The sailplan is stored in a volatile memory, which means that the
sailplan will be lost when the electrical power is cut. However the
individual waypoints (01-99) remain in the (Edit WP) memory.
NAVIGATION FUNCTIONS
To Next Page
Loading...
