45
To start navigation to waypoint number (06), continue from above
example and press UP until (Goto NXT) is displayed.
To unlock the value, press KEY.
To change from waypoint number (05) to (06), press UP.
To store the new value, press KEY.
From waypoint (05) to (06) the bearing is 345° and the distance
33.45 NM. It is also indicated that this is the first leg (*01).
The cross track error (XTE) function will be calculated with respect
to this new bearing and not as if the starting position was the
present position (00).
8.5.3 Cancel a leg in the sailplan
If the sub-function displays (Goto WP), it confirms the sailplan is
empty, that means that no waypoints are stored in it.
If the sub-function displays (Goto) and a number, example (Goto
3), it confirms the sailplan is ”active” (at least one waypoint is
stored in it), and that the Server is actually calculating navigation
data towards the displayed ”active” waypoint.
Select sub-function (Goto 3), press KEY.
To select the leg you want to cancel, press DOWN or UP.
To cancel the selected waypoint, press DOWN and UP together.
The next leg in the sail plan is displayed.
To exit from the function, press MODE.
8.5.4 Insert a waypoint in the sailplan
The function insert (In-SErt) allows you to rearrange the sailplan if
you want to insert or cancel a waypoint.
Example: Enter any 4 waypoints (Edit WP) , (see 8.4.2), and store
them in spailplan (Goto WP), (see 8.5.1), in the following leg
order:
Leg (*1) Go FROM (00) Goto NXT (01)
Leg (*2) Go FROM (01) Goto NXT (02)
Leg (*3) Go FROM (02) Goto NXT (03)
Leg (*4) Go FROM (03) Goto NXT (04)
Let us say that you change your plans and would like to go from
waypoint (02) direct to waypoint (04), that is to insert waypoint
(04) before leg (*3).
Since you are still in the dock and have not started your trip, the
display will indicate (Goto 1), based on above sailplan.
NAVIGATION FUNCTIONS
To Next Page
Loading...
