33
7.3 Set and turn on shallow (SHA) and depth alarm
(DEA)
Select shallow (SHA) or depth (DEA) alarm, press KEY.
The first digit in the previous value flashes.
If you want to reset the previous value to zero (0), Press DOWN
and UP together.
To select desired depth press DOWN, UP and MODE as required.
Press KEY to lock the selected value.
By this last press on KEY, you have turned on the selected alarm
function, which is indicated by the minute sign ( ´ ) above the last
depth digit in the sub-function.
7.4 Set and turn on anchor alarm (ANC)
Select anchor alarm (ANC), press KEY.
The first digit flashes.
The instrument will suggest a value for the shallow (SHA) alarm
(actual depth minus 1,5 m / 5 FT).
To store the value press KEY, or select your own depth as in 7.3.
The minute sign ( ´ ) is shown above the last depth digit in the
sub-function.
The instrument will suggest a value for the depth (DEA) alarm
(actual depth plus 1,5 m / 5 FT).
To store the value press KEY, or select your own depth as in 7.3.
The minute sign ( ´ ) is shown above the last depth digit in the
sub-function.
7.5 Clear an alarm value
Select the alarm function to be cleared, press KEY.
The first digit flashes.
To clear the alarm, press DOWN and UP together. All digits are
set to zero (0).
Press KEY to lock the function.
7.6 Silencing an alarm
To silence a triggered alarm that sounds and flashes, press ANY
button.
The sound is silenced and the flashing stops.
The alarm is only triggered again if the selected depth value is
exceeded (shallower or deeper) by 2 m (6 feet).
7.7 Turning off / on an alarm
Select the alarm function to be turned off / on.
To turn the alarm off / on, press DOWN and UP together.
The minute sign ( ´ ) disappears / appears.
DEPTH FUNCTIONS
To Next Page
Loading...
