Nexus Multi Control - Nmea; C79 to C94; C95 (D4 NME); Transmit NMEA Sentences out from Server

65
Example 2: To transfer waypoint number 1 to 50 from the Server
and store them in a NMEA navigator memory number 101 to 150,
set C78 WBN to 01 and C74 WPT to On.
12.6.10 C79 to C94
Contains 16 NMEA slots. (See 12.7.1)
12.6.11 12.6.11 C95 (d4 NME)
Damping for NMEA OUT from Server.
Only compass heading (HT/HM) and boat speed through water
(BSP) can be damped with this code.
d0 = 0.5 sec, d2 =1 sec, d3 = 2.5 sec, d4 = 5 sec, d5 = 10 sec,
d6 = 20 sec, d7 = .40 sec, d8 = 80 sec and d9 = 160 sec.
12.7 NMEA
12.7.1 Transmit NMEA sentences OUT from Server
Calibration code C79 to C94 contains 16 NMEA slots
The Server supports 29 different NMEA sentences.
This means you can select up to 16 of the 29 available NMEA
sentences.
The Nexus Network uses the NMEA 0183 sentences, version 1.5
and 2.0.
The number in brackets, example (C79), is the calibration code for the
factory slot number given to the NMEA sentence.
0 ( — ) No out signal
1 (APA) Autopilot A (older)
2 (APB) Autopilot B
3 (BOD) Bearing original destination
4 (BWC) Bearing and distance to waypoint
5 (C79) (BW1) Short version of BWC Maxi repeater)
6 (BWR) Bearing and distance, dead reckoning
7 (C80) (DBT) Depth measured from the transducers position
8 (DPT) Depth
9 (C81) (GLL) Geographic position
10 (C82) (HDM) Magnetic heading
11 (C83) (HDT) True heading
(C91)
12 (MTW) Water temperature
13 (C84) (MWD) Wind direction and speed
14 (MWV) Apparent wind speed and angle
15 (RMA) Minimum specific Loran-C data
16 (RMB) Minimum navigation data
17 (RMC) Minimum specific GPS- and TRANSIT-data
18 (C85) (VDR) Set and drift
19 (C86) (VHW) Speed and course through the water
CALIBRATION