73
2. Unstable or erratic readings. Can happen in the following cases:
• When going over shoal water, with uneven and high bottom
vege-tation.
• In heavy layers of salt or noticeable ranges of water
temperatures.
• In heavily agitated water containing particles of sand or some
other contamination.
The bottom of the transducer may be painted with anti fouling for
protection against weed growth. It is recommended the transducer
is cleaned at regular intervals depending on what kind of waters
you boat in.
Weed on the transducer can cause either no reading or unstable
readings.
In general when a boat is moored in a harbour with other boats
around, there can be disturbances from signals from other depth
transducers, chains or other mooring equipment, which will result
in wrong depth readings.
13.2.3 Error messages
The following error messages can appear on the display:
ERROR 2 Nexus Network is missing, check colour coded
connections
ERROR 3 No data received within a given time.
ERROR 10 Range error caused by bad format e.g. 17° 70'
East.
ERROR 11 Remote command that can not be performed.
ERROR 12 No response from, or missing navigator.
ERROR 13 Waypoint not defined.
ERROR 15 Functions not allowed in autopilot mode.
ERROR 16 Automatic deviation not possible due to NMEA
compass selected.
ERROR 17 Automatic deviation check failed. Turn not
completed, error larger than 1,5°.
ERROR 19 The boat probably hit a wave during turn. Error
larger than 1,5°.
If other error messages than the above appears on the Multi
Control instrument, contact your Nexus dealer.
MAINTENANCE AND FAULT FINDING
To Next Page
Loading...
