5.1 Preparation Before Use
DF1906
5.1 Preparation Before Use
The DF
1906 can be controlled by the USB Test and Measurement Class (hereinafter USB-TMC).
Almost all panel operations can be controlled and internal conditions such as setting values and errors
can be read.
・ The USB connector is located on the front panel.
・ USB is an interface that is supposed to be used in a relatively good environment. Avoid use in
places with frequent power fluctuations or noise.
Install a USB-TMC class driver on the controlling PC and connect it with a commercially-available
USB cable. The installation file of this driver can be downloaded from the National Instruments
Corporation website. The following describes the operation procedure until the driver is installed.
１． Search for the VISA Run-time Engine page at the National Instruments Corporation website, or
select "VISA driver downloads" at the following URL.
http://www.ni.com/support/visa/
２． Download VISA Run-time Engine from the VISA Run-time Engine page. At this point, you need
to register yourself as a user. For VISA Run-time Engine, download Version 3.3 or later.
３． The downloaded file is a self-extracting file. Extract and install the file.
４． When the installation is completed successfully, the USB-TMC class driver is installed.
For details, refer to the National Instruments Corporation website.
To Next Page
Loading...
