NF DF 1906 - DF 1906 SCPI Command Reference

5.2 Command List
DF1906
5-3
5.2 Command List
Table 5-1 shows a DF 1906 Command List. Table 5-2 shows IEEE488.2 common commands
corresponding to those in the DF
1906.
Symbols used in Table 5-2 have the meanings defined below. The lower-case characters in keywords
indicate that they can be omitted.
・ Square brackets ([ ]) indicate the keyword that can be omitted. (Suggestion keyword)
・ Vertical bar (|) indicates that one keyword is selected from multiple keywords.
Table 5-1 DF
1906 Command List
Function
Command
Output Frequency
[:SOURce]:FREQuency[:CW|:FIXed]
Amplitude
[:SOURce]:VOLTage[:LEVel][:IMMediate][:AMPLitude]
Amplitude Display
Unit
[:SOURce]:VOLTage:UNIT
DC Offset
[:SOURce]:VOLTage[:LEVel][:IMMediate]:OFFSet
Output High Level
[:SOURce]:VOLTage[:LEVel][:IMMediate]:HIGH
Output Low Level
[:SOURce]:VOLTage[:LEVel][:IMMediate]:LOW
Waveform
[:SOURce]:FUNCtion[:SHAPe]
Symmetry
[:SOURce]:FUNCtion:RAMP:SYMMetry
Duty Ratio
[:SOURce]:PULSe:DCYCle
Select Arbitrary
Waveform Number
[:SOURce]:FUNCtion:USER
Transfer Arbitrary
Waveform Data
:TRACe|DATA[:DATA]
Oscillation Mode
[:SOURce]:MODE
Mark Wave Number
[:SOURce]:BURSt:NCYCles
Space Wave
Number
[:SOURce]:BURSt:SPACes
Phase
[:SOURce]:PHASe
Burst Sync
:OUTPut:SYNC:TYPE
Trigger
:TRIGger[:SEQuence][:IMMediate]
Trigger Polarity
:TRIGger[:SEQuence]:SLOPe
Gate Level
[:SOURce]:BURSt:GATE:POLarity {NORMal|INVerted}
Output On/Off
:OUTPut[:STATe]
Initialize Settings
:MEMory:STATe:DELete
Output a t Power On
:SYSTem:PON[:OUTPut]
Select Load
:OUTPut:IMPedance
Error Query
:SYSTem:ERRor?