NF DF 1906 - Table 5-2 Common Commands ············································································

5.2 Command List
DF1906
5-4
Table 5-2 Common Commands
Common Command
and Query
Name
Function
*CLS
Clear Status Command
Clears the standard event status register.
*ESE
Standard Event Status Enable
Command
Sets the standard event status enable
register.
*ESE?
Standard Event Status Enable
Query
Queries the setting of the standard event
status enable register.
*ESR?
Standard Event Status Register
Query
Queries the standard event status resister.
*IDN?
Identification Query
Queries the ID information of the device.
*OPC
Operation Complete Command
Generates the operation complete
message (OPC) of the standard event
status register when the device operation
is complete.
* This equipment does not generate the
OPC message. (Always 0)
*OPC?
Operation Complete Query
Returns 1 when the device operation is
complete.
* This equipment always returns 0.
*RST
Reset Command
Executes device reset.
* This equipment performs the same
process as the setting memory
initialization.
*SRE
Service Request Enable Command
Sets the service request enable resister.
*SRE?
Service Request Enable Query
Queries the setting of the service request
enable resister.
*STB?
Read Status Byte Query
Queries the status byte and master
summary status bit.
*TRG
Trigger Command
Command to apply a trigger, which does
not do anything in this equipment. (An
error does not occur.) To set a trigger, use
the TRIGger subsystem command.
*TST
Self Test Query
Executes the self test of the device and
returns the result.
* This equipment always returns 0.
*WAI
Wait to Continue Command
Puts the equipment into the wait state
until all commands and queries that have
been received before are finished.
* This equipment does not do anything.
(An error does not occur, either.)
*RCL
Recall Command
Reads the content of the specified setting
memory.