Nice WIL Instructions And Warnings For The Fitter

5
GB
2.1) Operating limits
Chapter 9 “Technical Characteristics” provides the only data needed to determine whether the products are suitable for the intended appli-
cation.
2.2) Typical system
NOTE: This diagram only shows a possible application of the unit and should be considered merely as an example. Only an in-depth analy-
sis of the risks of the “Machine” gate and a proper evaluation of the end user requirements will be able to establish how many and which ele-
ments must be installed.
1. WIL Barrier
2. Selector post
3. Key-operated selector switch
4. Radio keypad
5. Photocell post
6. pair of PHOTO photocells
7. Luminous indicator
8. Luminous indicator
9. Closing rod
10. Sensitive edge on PHOTO 1
11. Adhesive warning strip
12. flashing light
13. RADIO aerial
14. Radio transmitter
2
2.3) List of cables
The typical system shown in figure 2 also states the cables required for connection of the various devices, the specifications of which are
provided in table 1.
The cables used must be suitable for the type of installation; for example, an H03VV-F type cable is recommended
for indoor applications, while H07RN-F is suitable for outdoor applications.
!
Note 1: power supply cable longer than 30 m may be used provided it has a larger gauge, e.g. 3x2,5mm
2
, and that a safety earthing sys-
tem is provided near the automation unit.
Connection Cable type Maximum admissible length
A: Electrical power line N°1 cable 3x1,5mm
2
30m (note 1)
B: Flashing light N°1 cavo 2x0,5mm
2
20m
C: Aerial N°1 shielded cable type RG58 20m (less than 5m recommended )
D: Photocells N°1 cable 2x0,25mm
2
(Tx) 30m
N°1 cable 4x0,25mm
2
(Rx) 30m
E: Key-operated selector switch N°1 cable 4x0,25mm
2
30m
F: Sensitive edge N°1 cable 2x0,25mm
2
30m
G: Photocells N°1 cable 2x0,25mm
2
30m
N°1 cable 4x0,25mm
2
30m
Table 1: List of cables

Nice WIL Specifications

General

Brand	Nice
Model	WIL
Category	Other
Language	English