Controlling Initial Start of Car Motion
42-02-7223 C1 4-25
4
iControl DC
28. Remove all weights from inside the car.
29. On the Configuration > Drive > Pretorque tab, deselect Acquire Location Data. Send the
new selection to the controller.
30. On the Configuration > Drive > Pretorque tab, select Empty/Full Load as the Pre-
torque Method. Send the new selection to the controller.
31. The pretorque table is now fully configured and available.
32. Check for rollback throughout the hoistway and verify that no rollback is detected.
33. Reduce Speed Pick Delay 1, on the Configuration > Brake > Control tab, to the minimum
value which still allows the brake to lift fully before motion starts. You should not feel
the car pulling out from under the brake. The brake should lift fully before motion
starts, but avoid unnecessary delay in starting movement.
If this car will be using the load weigher for dispatching functions, e.g. Light load anti-nuisance,
etc., you may want to set the parameters and learn the load values at this time. Please refer to
“Load Weigher Adjustment for Dispatching ” on page 4-38.
To Next Page
Loading...