Nikon D100 VBA10201 - Page 77

VBA10201-R.3577.A
- A47
･
-
Fig. 2
• TFT display position adjustment
(1) Supply the power to the camera from the AC power supply.
(2) Connect the USB cable to the camera.
(3) Select “TFT display position adjustment” in “Contents” on the menu display.
(4) Press the START button. Perform the procedure according to the instructions on the screen.
(5) Select “NTSC” and adjust the display position by clicking the “UP”, “DOWN”, “LEFT” and “RIGHT”
buttons.
(6) Adjust “PAL” in the same way and then press the OK button to end the adjustment.
(7) Remove the USB cable from the camera and then remove the AC cable.
Fig. 3
• CCD defect compensation
(1) Supply the power to the camera from the AC power supply.
(2) Set the body cap onto the camera to prevent the light from entering through the mount surface.
(3) Connect the USB cable to the camera.
(4) Select “CCD defect compensation” in “Contents” on the menu display.
(5) Press the START button. Perform the procedure according to the instructions on the screen.
(6) The adjustment result is displayed at the result display position. If “OK” is displayed, the adjustment is
normally ended. If the adjustment is NG, “NG” is displayed and the contents of the error are displayed in
the column of “COMMENT”.
(7) Remove the USB cable from the camera and then remove the AC cable.
+
-
Battery tool
(Non resistor)
V
A