▪ +NEF (RAW)** (D300S only) – If you are a regular
JPEG shooter, and have JPEG fine, normal, or basic
selected as your normal image capture format, you can
use the Selected button to temporarily switch to NEF
(RAW) mode. Once you take the RAW format picture,
the camera switches back to JPEG. If you decide not to
take the NEF (RAW) picture, just press the Selected
button again to return to JPEG mode. Setting this
function disables other functionality in the D300(S).
Please see the** note at the end of this section. This
function applies to the D300S only.
▪ None (default) – When this setting is enabled, the
Selected button does nothing.
** Important note: If you decide to use this particular
function, please realize that it will disable the Selected button
+ command dials feature of the camera. You’ll see a warning
on the screen when you set it, but by then it will have turned
the Selected button + command dials to None. If you then go
back and try to set a value under Selected button + command
dials, the camera will give you a warning and set the Selected
button function to None. Both cannot be used at the same
time (i.e., they are mutually exclusive).
Selected button + command dials
▪ 1 step spd/aperture (Fn button + dials and Preview
button + command dials only) – If you have Custom
setting b2 (EV steps for exposure cntrl.) set to 1/3 step
like most photographers, you can change your camera’s
shutter speed and/or aperture in 1/3 EV steps, while in
A-Aperture priority, S-Shutter priority, and M-Manual.
However, you may want to use larger EV steps
407
To Next Page
Loading...
