Method 2 – Manual White Balance
Using the Shooting Menu
This method is similar to Method 1, but it uses the Shooting
Menu screens to select the Kelvin range. Instead of using the
WB button and Sub-command dial, you’ll open up your
menus and set the color temperature by selecting from them.
Here are the screens and steps used to select a White balance
setting (see Figure 10-11):
Figure 10-11. Shooting Menu White balance screens
1. Select White balance from the Shooting Menu and scroll
to the right.
2. Select one of the preset values, such as Flash or Cloudy,
and scroll to the right.
3. Press the OK button immediately, without moving the
little square from its center position.
Normally you’ll use only the first two screens (in
Figure 10-11) to select one of the preset WB values, such as
Cloudy, Shade, or Direct sunlight. Then you’ll just press the
695
To Next Page
Loading...
