button halfway down to activate the meter and then
scroll the AF point around the Viewfinder. When Reset
meter-off delay is selected, any usage of the Multi
Selector causes the light meter to come on. Custom
setting C2 (Auto meter-off delay) controls how long it
stays on; the default is 6 seconds.
▪ Do nothing – If the light meter is off, it stays off when
you press the Multi Selector.
My Recommendation: Recently, I’ve started leaving my
camera set to Reset meter-off delay so that any use of the
Multi Selector will keep my camera’s meter from going off.
The only drawback is shorter battery life, since this will tend
to keep the meter on longer.
Photo Info/Playback
Custom setting f4 (D300S) and f3 (D300)
(User’s Manual – D300S page 292; D300 page 302)
Photo info/playback determines how the Multi Selector
functions when you are scrolling in the Info and Playback
screens (see Figure 4-71, image 3). The default for image
viewing is to press the Multi Selector to the left or right. To
view the Info screens for a particular image, you scroll up or
down when the image is on the Monitor.
If you don’t like it that way you can reverse it. Then you’ll
review images by pressing up or down on the Multi Selector
and view the Info screens by pressing left or right.
396
To Next Page
Loading...
