Nikon D3S - Page 345

319
U
❚❚ Portrait (Tall-Orientation) Photographs
To use the command dials to select the focus point when framing
shots in portrait (“tall”) orientation:
1 Choose Focus point-selection.
Select Focus point-selection for
Custom Setting f4 (Assign Fn
button)>Fn button + command
dials.
v
1 step spd/
aperture
If the Fn button is pressed when the command dials are
rotated, changes to shutter speed (exposure modes f
and h) and aperture (exposure modes g and h) are
made in increments of 1 EV, regardless of the option
selected for Custom Setting b2 (EV steps for exposure
cntrl., 0 302).
w
Choose non-
CPU lens
number
Press the Fn button and rotate a command dial to
choose a lens number specified using the Non-CPU
lens data option (0 214).
x
Focus point-
selection
Press the Fn button and rotate the command dials for
vertical shooting to choose a focus point.
n
Shooting
menu bank
If this option is selected, the shooting menu bank can
be selected by pressing the Fn button and rotating a
command dial.
I
Dynamic AF
area
If continuous-servo AF (focus mode C; 0 90) is selected
when dynamic-area AF (I) is chosen for AF-area mode
(0 92), the number of focus points can be selected by
pressing the Fn button and rotating a command dial
(0 296). The focus points used for dynamic-area AF are
displayed in the viewfinder while the Fn button is
pressed; if 51 points (3D-tracking) is selected, “3D”
will be displayed in the viewfinder.
None
No operation is performed when the command dials
are rotated while the Fn button is pressed.
Option Description