Chapter 5 Laser Unit
5.4 LU4A Four-laser Module A
1-180
Figure 5.4-67
10. Attach the centering tool to position C and adjust the
laser coupling mirror part in both horizontal and
vertical directions so that the laser light enters the
hole L.
11. Tighten the clamp screws on the laser coupling
mirror part to secure it.
< for LU4 > (Do not use in this system.)
In this section, the green HeNe laser and the 561-nm solid-state laser are described as examples.
Figure 5.4-68
4. Attach the centering tool to the collimation pin of the
L4 dichroic mirror adjustment part. Rotate the
centering tool so that the laser light enters the hole o
the centering tool at a right angle.
Figure 5.4-69
5. Put a target such as a piece of paper in the optical
path away from the centering tool.
6. Manually open the L4 laser shutter.
Position C
Centering tool Hole L
Laser coupling mirror part
Clamp screws
Centering tool
To Next Page
Loading...