NLB 1012D - Page 154

Revision 6
Note:
A 7/8" (22.2 mm) section, cut from the 0-ring (Item #14) can be used to plug the
Cap
Nut (Item #8) vent hole (Figure 8-58). Performing this task will prevent oil
leakage
if the BV10-650 By-Pass Valve is shipped or stored in the horizontal
position. The
0-ring can be left in while the valve is in operation.
Figure 8-58. Plugging the vent hole.
© Copyright October, 2001 NLB Corporation 8-48