Configure a G-240W-C indoor ONT
120
7368 ISAM ONT G-240W-C Product Guide
3FE-46256-AAAA-TCZZA Issue: 01
Table 44 Access control parameters
2 Select a WAN connection from the drop-down menu.
3 Click to enable or disable Trusted Network.
4 Select an access control level for each of the four protocols: ICMP, SSH, HTTP, and TR-069
for both the WAN and the LAN side.
5 Click Save.
6 Optionally, add one or more subnet trusted networks.
The maximum number of entries is 32.
You can also use the Source IP fields to delete a previously created entry for a subnet trusted
network.
7 STOP. This procedure is complete.
7.2.5 Application configuration
G-240W-C ONT also supports application configuration, including:
• port forwarding
• port triggering
• DDNS
• NTP
• USB
• UPnP and DLNA
• voice setting
Field Description
WAN Choose a connection from the drop-down menu
Trusted Network Enable Click to enable or disable
ICMP, SSH, HTTP, TR-069 Select an access control level for each protocol:
WAN side: Allow, Deny, or Trusted Network Only
LAN side: Allow or Deny
Source IP Start Enter a start IP address for the new subnet trusted network
Source IP End Enter an end IP address for the new subnet trusted network
Release 06.01.00 | March 2019 | Edition 12
To Next Page
Loading...
