Configure a G-240W-C indoor ONT
148
7368 ISAM ONT G-240W-C Product Guide
3FE-46256-AAAA-TCZZA Issue: 01
Procedure 56 Modifying the operator ID
1 Register the ONT with the OLT.
2 Using an XML editor, create a file called OntConfig.xml with the following content:
<OperatorObject version=”1.0”>
<OperatorID=”abcd”>
</OperatorObject>
where: abcd is the correct operator ID, for example ALCL for HGU mode with TR-069 or TR-104 voice
management, ALCO for HGU mode with OMCI V1 or V2 voice management, or XXXX for generic SFU mode.
3 Use a TFTP client tool to transfer the OntConfig.xml file to the OLT’s ONT directory and
change the filename to the software version number, for example, 3FE123456789.xml.
See the OLT documentation for the location of the ONT directory.
4 Use a TL1 command to configure ONUSWCRTL:
ENT-ONTSWCTRL::1::::HWVER=hwver,VARNT=,PLNDSWVER=UNPLANNED,
PLNDSWVERCONF=UNPLANNED,DLDSWVER=swver;
where:
hwver is the EQPTVERNUM, for example EQPTVERNUM=3FE12345AAAA.
swver is the software version number used as the filename in step 2, for example 3FE123456789.xml.
See the TL1 Commands and Messages Guide for the 7342 or 7360 for more information
about the ENT-ONTSWCTRL command.
5 Download the xml file to update the operator ID:
ED-ONT::ONT-1/1/3/1/19::::DLSW=AUTO;
6 Restart the ONT, then connect to the LAN and use the T&D command on the ONT console
(ri tool dump) to check the OPID.
7 Use a TL1 command to disable further downloads:
ED-ONT::ONT-1/1/3/1/19::::DLSW=DISABLED;
To enable auto download again, use the DEL-ONTSWCTRL command. See the TL1
Commands and Messages Guide for the 7342 or 7360 for more information about the
DEL-ONTSWCTRL command.
8 STOP. This procedure is complete.
Release 06.01.00 | March 2019 | Edition 12
To Next Page
Loading...
