IP390 Security Platform Installation Guide 13
About This Guide
This guide describes how to install and use Nokia IP390 security appliances. Installation and
maintenance should be performed by experienced technicians or Nokia-approved service
providers only.
This preface provides the following information:
In this Guide
Conventions this Guide Uses
Related Documentation
In this Guide
This guide is organized into the following chapters and appendixes:
Chapter 1, “Overview” presents a general overview of the IP390 appliance.
Chapter 2, “Installing the Nokia IP390 Appliance” describes how to rack-mount the
appliance and how to physically connect it to a network and power.
Chapter 3, “Performing the Initial Configuration” describes how to make the appliance
available on the network.
Chapter 4, “About IP390 Appliance Network Interface Cards” describes how to connect to
and use each of the supported NICs.
Chapter 5, “Installing and Replacing Network Interface Cards” describes how to install,
monitor, and replace network interface cards (NICs).
Chapter 6, “Installing and Replacing Components Other than Network Interface Cards”
describes how to install or replace compact flash memory cards, flash-memory PC cards,
RAM memory, and a hard-disk drive.
Chapter 7, “Troubleshooting” describes problems you might encounter and proposes
solutions to these problems.
Appendix A, “Technical Specifications” provides technical specifications such as interface
characteristics.
Appendix B, “Compliance Information” provides compliance and regulatory information.
To Next Page
Loading...
Need help?
General
