4 About IP390 Appliance Network Interface Cards
38 IP390 Security Platform Installation Guide
Compliance with IEEE 802.3 Ethernet specification
You can configure and monitor Ethernet interfaces with Nokia Network Voyager. Specifically,
you set the port speed and full-duplex or half-duplex mode by using Network Voyager.
The following figure shows Ethernet NIC front panel and LED details.
Figure 9 Four-Port Ethernet NIC Front Panel Details
After the power is turned on, the Ethernet link LEDs on the appliance and on the remote
equipment illuminate to indicate the connection. As data is transmitted, the activity LEDs on the
appliance light up.
Ethernet NIC Connectors and Cables
The connectors on the Ethernet NIC are RJ-45 connectors:
To connect to a hub, use a straight-through RJ-45 cable.
To connect directly to a host, use an RJ-45 crossover cable.
For further details about cables that you should use, see “NIC Interfaces” on page 88.
Caution
Cables that connect to the Ethernet NIC must be IEEE 802.3 compliant to prevent
potential data loss.
You can order appropriate adapter cables separately. You can order additional cables from a
cable vendor of your choice.
00641
321
1
2
3
4
4
1000 BaseT
Link LEDs (solid green)
Activity LEDs (blinking green)
Ports
To Next Page
Loading...
Need help?
General
