Nokia IP390 - Security Appliance - Before You Start; Figure 22 Hard-Disk Drive Location

6 Installing and Replacing Components Other than Network Interface Cards
62 IP390 Security Platform Installation Guide
Figure 22 Hard-Disk Drive Location
Before You Start
To install or replace the hard-disk drive in your appliance, you need the following:
 Physical access to the appliance
 A Nokia-approved hard-disk drive
 Access to the appliance through Network Voyager
 A Phillips-head screwdriver
 A torque screwdriver capable of a 69.4ozf*in (5kgf*cm) setting
To install or replace a hard-disk drive
1. Use Network Voyager or the CLI to halt the appliance.
To use Network Voyager to shut the appliance down, select
System > Configuration > Reboot or Shutdown > Halt.
To use the CLI to do this, enter halt at the prompt.
00542
IP390
Hard-disk drive