Nokia IP390 - Security Appliance User Manual

6 Installing and Replacing Components Other than Network Interface Cards
68 IP390 Security Platform Installation Guide
To add or replace DIMMs
1. Use Network Voyager or the CLI to halt the appliance.
To use Network Voyager to shut the appliance down, select
System > Configuration > Reboot or Shutdown > Halt.
To use the CLI to do this, enter halt at the prompt.
2. Loosen the two front panel retaining screws.
3. Gently slide the chassis tray assembly forward to expose the DIMM sockets. Remove the
tray completely to avoid damaging components.
Note
Because power to an IP390 appliance is automatically disconnected when the chassis tray
assembly is opened, you do not need to manually disconnect the power for this procedure.
Any servicing of the unit, however, should be completed with the chassis tray assembly fully
removed from the appliance. Power is still active in the chassis body and care should be
taken when working on the power supply or power supply wiring without disconnecting the
power cord.
00525
IP390
Chassis tray assembly retaining screws
00537
IP390

Nokia IP390 - Security Appliance Specifications

General

Brand	Nokia
Model	IP390 - Security Appliance
Category	Network Hardware
Language	English