Replacing the Compact Flash Memory Card
IP560 Security Platform Installation Guide 111
Caution
To protect the appliance and the compact flash memory from
electrostatic discharge damage, make sure you are properly
grounded before you touch these components. Use a grounding
wrist strap and follow the instructions provided with the wrist strap
before you handle the components or open the appliance. If you do
not have a grounding wrist strap, make sure you are properly
grounded before you touch any electronic component.
You must perform an orderly shutdown of the appliance and turn the power
off whenever you remove the chassis tray assembly to service internal
components.
Caution
You risk damage to the appliance or loss of data if you do not use the
following procedure when you replace the compact flash memory.
1. Use Nokia Network Voyager or the command-line interface (CLI) to
perform an orderly shutdown of the IP560 appliance.
For information about how to access Network Voyager and the related
reference materials, see “To open Nokia Network Voyager” on page 52.
2. Turn off the power to the IP560 appliance.
Note
Make sure you turn off the power supply.
To Next Page
Loading...
