Nokia IP560 - Configuring and Activating Interfaces

4 Installing and Replacing Network Interface Cards
64 IP560 Security Platform Installation Guide
10. Insert and close the chassis tray assembly until it clicks into place.
The Nokia IPSO operating system automatically recognizes the NIC and
applies the original configuration to the new NIC.
11. Tighten the retaining screws that hold the chassis tray assembly.
12. Turn the power on.
Configuring and Activating Interfaces
The IP560 appliance automatically detects any new NIC when the appliance
is restarted. Use Nokia Network Voyager to configure and activate the logical
and physical interfaces on the NIC.
SLOT 1
SLOT 2
SLOT 3
SLOT 4
1
2
3
4
IP560
00519
00354
SLOT 1 SLOT 2 SLOT 3 SLOT 4
1
2
3
4
IP560
Chassis tray assembly retaining
screws