Nokia IP560 - Installing a Hard-Disk Drive

8 Replacing Other Components
116 IP560 Security Platform Installation Guide
 Using the CLI, enter the command:
set optional-disk device-id <1 | 2> off
where the number 1 or 2 indicates the PC-card slot.
2. Perform a system shutdown by using Network Voyager or the CLI halt
command.
3. Press the eject button to remove the PC card.
Caution
To prevent the card from ejecting too quickly, hold the PC card while
you push the eject button.
4. Reboot the system.
Installing a Hard-Disk Drive
The IP560 is a flash-based appliance that also supports one or two optional
hard-disk drives that plug into connectors on the motherboard. Each hard-disk
drive contains 40 GB of storage space.
The hard-disk drives are not included in the standard package. When you
purchase your IP560, you can order one or two hard disk drive(s) for factory
installation or order them later and install them yourself, as described in this
chapter.
You can use a single hard disk drive for storing log files.
This section describes how to install a hard-disk drive.