Nokia IP560 - Connecting Power and Turning the Power on; Figure 11 Power Switch Location

Connecting Power and Turning the Power On
IP560 Security Platform Installation Guide 47
port of the IP560. You can easily remove the console cable by pulling
back on the shroud.
If you connect the console port to a data communications equipment
(DCE) device, use a straight-through cable.
For cable pin assignments for the console connection, see “Console Port”
on page 25.
2. Connect the other end of the cable to the VT100 console or to a system
running a terminal-emulation program.
Connecting Power and Turning the Power On
A power switch and a receptacle for the power cord are located on each power
supply on the back of the appliance as shown in Figure 11.
Figure 11 Power Switch Location
00350
SLOT 1 SLOT 2 SLOT 3 SLOT 4
1
2
3
4
IP560
Console port
0035
3
Power cord receptacle
Power switch
Power supply