Four-Port 10/100 Ethernet NIC
IP560 Security Platform Installation Guide 69
Tracing through tcpdump
High bandwidth
Full-duplex mode operation up to 100 Mbps
Link speed auto advertising (10/100)
Cable autosensing
PCI operation at 133 MHz
Compliance with IEEE 802.3ab Gigabit Ethernet specifications
You can configure and monitor Ethernet NIC interfaces by using Nokia
Network Voyager. Specifically, you set the port speed and full-duplex or
half-duplex mode with Network Voyager.
For information about how to access Network Voyager and the related
reference materials, see “Accessing Nokia Network Voyager Reference
Information” on page 53.
Figure 13 Four-Port 10/100 Ethernet NIC Front Panel Details
After the power is turned on and the cables are connected, the Ethernet link
LEDs on both the IP560 and on the remote equipment illuminate to indicate
the connection. As data is transmitted, the activity LEDs on the appliance
illuminate.
00026.2
321
1
2
3
4
4
10/100 BaseT
Activity LED (blinking green)
Link LED (solid green)
Ports
To Next Page
Loading...
