3 Performing the Initial Configuration
52 IP560 Security Platform Installation Guide
For details, see “Multi-Mode Fiber-Optic Gigabit Ethernet NIC Features”
on page 77.
Using Nokia Network Voyager to Manage Your
Security Platform
Use Nokia Network Voyager to configure and monitor your IP560. For
additional information about how to use Network Voyager, see “Accessing
Nokia Network Voyager Reference Information” and “Nokia Network
Voyager Inline Help” on page 54.
To open Nokia Network Voyager
1. Start a Web browser on the host you plan to use to configure or monitor
your appliance.
2. In the Location or Address field, enter the IP address of the initial
interface you configured for the appliance.
You are prompted to enter the admin username and the password you
entered when you performed the initial configuration.
For more information, see the section in the appropriate installation guide
about entering passwords.
Note
If the username login screen does not appear, you might not have a
physical network connection between the host and your appliance, or you
might have a network routing problem. Confirm the information you
entered during the initial configuration and check that all cables are firmly
connected. For more information, see the troubleshooting chapter in the
appropriate installation guide.
To Next Page
Loading...
