Installing NICs
IP560 Security Platform Installation Guide 59
Voyager. For additional information, see “Deactivating Configured
Interfaces” on page 58.
Use these instructions to install a NIC in the IP560. Some steps are not
applicable to all procedures. The instructions point out steps appropriate to
each procedure.
Before You Begin
To install a Nokia NIC, you need the following:
A Phillips-head screwdriver
Physical access to the appliance
Access to the appliance by using Nokia Network Voyager or the CLI
A suitable, grounded work surface
A field replaceable unit kit, including the NIC
Note
You do not need to manually disconnect power for this procedure. If the
power supply switch at the rear of the appliance is difficult to reach, you
can safely disconnect power when you remove the chassis tray assembly
from the front of the appliance. Any servicing of the appliance, however,
should be completed with the chassis tray assembly fully removed from
the appliance.
To install a network interface card
1. Use Nokia Network Voyager or command-line interface (CLI) to perform
an orderly shutdown of the IP560 appliance.
For information about how to access Network Voyager and the related
reference materials, see “To open Nokia Network Voyager” on page 52.
2. Turn off the power to the IP560 appliance.
To Next Page
Loading...
