8 Replacing Other Components
140 IP560 Security Platform Installation Guide
Replacing a Power Supply
The appliance or gateway supports one 225-watt power supply. The power
supply is autosensing and can accept input voltages between 47Hz-64Hz and
85VAC-264VAC. The power supply output is regulated to a tolerance of
± 5 percent of the specified output voltage.
Before You Begin
To install or replace a power supply, you need:
Physical access to the appliance or gateway
A Phillips-head screwdriver
A replacement power supply and appropriate supplement
Figure 25 Power Supply Location
Caution
You should have working knowledge of networking equipment before
you attempt to service an appliance or gateway. Limit service to the
procedures described in this document.
00353
AC power receptacle
Integrated power supply
cooling fan
Power supply switch
Power supply
To Next Page
Loading...
