3 Performing the Initial Configuration
48 IP560 Security Platform Installation Guide
Caution
To avoid potential service interruptions from momentary facility
power interruptions and potential power spikes that might damage
your equipment, Nokia strongly recommends that you use an
uninterruptible power supply (UPS) with surge protection with your
IP560.
To connect the power supply
1. Connect the power cord securely into the power cord receptacle on the
power supply.
2. Plug the other end of the power cord into a three wire grounded power
strip or wall outlet.
3. Toggle the 1/O power switch to the 1 position to provide power to the
IP560.
The fan unit on the power supply turns on when you press the power
switch. Verify that the power supply fans are running after you press the
switch.
Note
The IP560 power supply automatically detects the input voltage (115
VAC or 220 VAC [85 to 264]) and configures itself appropriately.
4. Check the power LED (the Nokia logo) on the front panel of the appliance
to ensure that the power supply is operating correctly.
The power LED should be illuminated. For more information about the
system status LEDs, see “System Status LEDs” on page 27.
If the fans are not running, or if the power LED is not illuminated, make sure:
The power cord is properly connected.
The power supply switch is on.
To Next Page
Loading...
