8 Replacing Other Components
136 IP560 Security Platform Installation Guide
9. Place the screws through the standoff holes on the card and into the
standoffs on the motherboard.
10. Turn each screw clockwise to attach the card to the standoffs. Do not
overtighten.
Make sure that all four standoff connections are properly aligned before
tightening the screws completely.
11. Slide the chassis tray assembly back into the appliance until it clicks into
place resecure the two retaining screws.
12. Configure your software to use hardware acceleration by following the
instructions in “Configuring Software to Use Hardware Acceleration” on
page 137.
00175.1
Screw
Accelerator card
Standoff hole
Motherboard standoff
SLOT 1
SLOT 2
SLOT 3
SLOT 4
1
2
3
4
IP560
00359
To Next Page
Loading...
