NONLINEAR LABS C15 - Page 78

Parameter Reference
Parameter Reference
154 155
Determines the influence of the “Bender” Hardware Source
on Macro Control A.
The amount can be adjusted continuously [in percent] and
can cover the whole range of the Macro Control in both
directions (-100.0 % … 100.0 %).
Determines the influence of the “Bender” Hardware Source
on Macro Control B.
The amount can be adjusted continuously [in percent] and
can cover the whole range of the Macro Control in both
directions (-100.0 % … 100.0 %).
Hardware Amounts
Hardware Amounts
Determines the influence of the “Bender” Hardware Source
on Macro Control C.
The amount can be adjusted continuously [in percent] and
can cover the whole range of the Macro Control in both
directions (-100.0 % … 100.0 %).
Determines the influence of the “Bender” Hardware Source
on Macro Control D.
The amount can be adjusted continuously [in percent] and
can cover the whole range of the Macro Control in both
directions (-100.0 % … 100.0 %).
Determines the influence of the “Aertouch” Hardware
Source on Macro Control A.
The amount can be adjusted continuously [in percent] and
can cover the whole range of the Macro Control in both
directions (-100.0 % … 100.0 %).
Determines the influence of the “Aertouch” Hardware
Source on Macro Control B.
The amount can be adjusted continuously [in percent] and
can cover the whole range of the Macro Control in both
directions (-100.0 % … 100.0 %).
Determines the influence of the “Aertouch” Hardware
Source on Macro Control C.
The amount can be adjusted continuously [in percent] and
can cover the whole range of the Macro Control in both
directions (-100.0 % … 100.0 %).
Determines the influence of the “Aertouch” Hardware
Source on Macro Control D.
The amount can be adjusted continuously [in percent] and
can cover the whole range of the Macro Control in both
directions (-100.0 % … 100.0 %).
Determines the influence of the “Ribbon 1” Hardware Source
on Macro Control A. If the Ribbon is a returning Hardware
Source, the amount can be adjusted continuously, otherwise
it will be switch-like. Continuous amounts can be set [in
percent] and can cover the whole range of the Macro Control
in both directions (-100.0 % … 100.0 %).
Determines the influence of the “Ribbon 1” Hardware Source
on Macro Control B. If the Ribbon is a returning Hardware
Source, the amount can be adjusted continuously, otherwise
it will be switch-like. Continuous amounts can be set [in
percent] and can cover the whole range of the Macro Control
in both directions (-100.0 % … 100.0 %).
Determines the influence of the “Ribbon 1” Hardware Source
on Macro Control C. If the Ribbon is a returning Hardware
Source, the amount can be adjusted continuously, otherwise
it will be switch-like. Continuous amounts can be set [in
percent] and can cover the whole range of the Macro Control
in both directions (-100.0 % … 100.0 %).
Determines the influence of the “Ribbon 1” Hardware Source
on Macro Control D. If the Ribbon is a returning Hardware
Source, the amount can be adjusted continuously, otherwise
it will be switch-like. Continuous amounts can be set [in
percent] and can cover the whole range of the Macro Control
in both directions (-100.0 % … 100.0 %).