NORDAC FLEX (SK 200E ... SK 235E) – Brief instructions for Frequency Inverters
14 BU 0240 en-US-4920
Installation, maintenance and repair work must not be carried out unless the device has been de-
energized and at least 5 minutes have elapsed since line power has been disconnected! (Due to
charged capacitors, the device may continue to carry hazardous voltages for up to 5 minutes after line
power has been disconnected). Before starting work it is essential to check by measurement that all
contacts of the power plug connectors or terminals are de-energized.
Please refer to the device manual for further information.
Pos: 36 .14 /A nleitu ngen/ Elektr onik /FU und St art er/1. Al lgemei nes/ Sich erheits - und Ins tall ations hinw eise un d Warn- Gefahrenhinw eise/neu/Sicherheits- un d Instal lati onshi nweis e - Einzel pu nkte/ 4_g . E ntsor gu ng ( Sic her hei tshi nw eise) @ 19\mod_1508749472287_14638. docx @ 2 368 977 @ @ 1
Disposal
Do not dispose of the product and its parts and accessories as domestic waste. At the end of its life,
dispose of the product properly according to the local regulations for industrial waste. In particular,
please note that this product contains integrated semiconductor circuits (PCBs and various electronic
components, including high-power electrolytic capacitors). In case of incorrect disposal, there is a risk
of formation of toxic gases, which may cause contamination of the environment and direct or indirect
injuries (e.g. chemical burns). When it comes to high-power electrolytic capacitors, there is also a risk
of explosion with the associated risk of injury.
Pos: 36 .15 /A nleitu ngen/ Elektr onik /FU und St art er/1. Al lgemei nes /Sic her heit s- un d Install atio nshinw eis e und War n- Gefahrenhinw eise/neu/Sicherheits- un d Inst allati onshi nweis e - Einzel pu nkte/ 5. Expl osi ons gef ähr det e Umg eb ung ( AT EX) [SK 1xx E, S K 2xx E] @ 21\mod_1528787805877_14638.docx @ 2425670 @ @ 1
5. Potentially explosive environment (ATEX, EAC Ex)
In order to operate or carry out installation work in potentially explosive environments (ATEX,
EAC Ex), the device must be approved and the relevant requirements and instructions in the device
manual must be complied with.
Failure to comply can result in the ignition of an explosive atmosphere and fatal injuries.
• Only persons who are qualified, i.e. trained and authorized for all assembly, service,
commissioning and operation activities in connection with explosive environments may work with
the devices described here (including the motors, geared motors, any accessories and all
connection equipment).
• Explosive concentrations of dust may cause explosions if ignited by hot or sparking objects. Such
explosions may cause serious or fatal injuries to persons or severe material damage.
• The device must comply with the specifications of the "Planning Guideline for Operating and
Installation Instructions B1091" B1091-1
.
• Only original parts which are approved for the device and for operation in an explosive environment
(ATEX zone 22 3D, EAC Ex) must be used.
• Repairs may only be carried out by Getriebebau NORD GmbH & Co. KG.
Pos: 37 /A llg em ein/ Allg em eing ülti ge M od ule/ ---------Seite num bruc h kom pak t --------- @ 13 \mod_1476369695906_0.docx @ 2265496 @ @ 1
To Next Page
Loading...
Need help?
General
