Nord Drivesystems NORDAC FLEX SK 215E Series Brief Instructions

NORDAC FLEX (SK 200E ... SK 235E) – Brief instructions for Frequency Inverters
24 BU 0240 en-US-4920
Pos: 75 /A nl eitu nge n/El ek tro nik/FU u nd S tart er/ 2. M o ntag e un d Ins tall ati on/M o ntag e/M otor mo ntag e - St andar d [SK 1xxE, S K 2xxE]/ Mon tag e Is oli erpl att e – B augr öße 4 [SK 2xx E] @ 10\mod_1456819981747_14638.docx @ 310877 @ 35 @ 1
2.1.1 Installation of insulating plate – size 4
As of hardware status EA
A of the variable frequency drive
(suitable connection unit hardware status EA), a toroidal core
must be fitted to the insulating plate (motor terminal cover).
The toroidal core and the required fastening materials are
included in the scope of delivery of the connection unit.
The toroidal core is required to ensure that EMC requirements are met.
Assembly sequence
1
Secure toroidal core with cable ties
as shown in the figure to the left (pay
attention to insulating plate
alignment).
2
Remove terminal blocks (b).
3
Connect wiring harness (motor
cable) and lead through the toroidal
core attached to the insulating plate.
4
Wire motor cable to connecting
terminals U – V – W of the relevant
terminal block.
5
• Mount insulating plate (see
illustration in step 2 – (a)).
• Mount terminal blocks (see
illustration in step 2 – (b)).
Pos: 76 /A llg em ein/ Allg em eing ülti ge M od ule/ ---------Seite num bruc h kom pak t --------- @ 13 \mod_1476369695906_0.docx @ 2265496 @ @ 1

Nord Drivesystems NORDAC FLEX SK 215E Series Specifications

General

Brand	Nord Drivesystems
Model	NORDAC FLEX SK 215E Series
Category	Inverter
Language	English