Installation
3-10
Part 1618871−01
2020 Nordson Corporation
Manual Spray Gun Controller First-Time Startup
NOTE: Refer to the Encore Enhance Powder Spray Controller manual for
operation information for the manual gun controller.
The manual spray gun controller addresses are set through software. Each
controller must have a unique address, along with updating other specific
controller functions for basic operation.
When power is applied to spray controller, the function/help display screen
will quickly scroll through function settings.
The following controller functions must be set up for basic operation.
Table 3-4 Controller Basic Function Settings
Function
Number
Function
Name
Function
Values
F00 Gun Type 00 = Manual 01 = Auto 02 = Robot 03 = Manual with
Light on Gun
F20 Gun Number 01−32 for Auto
01−04 for Manual
F38
Flow Serial Number VVYYMNNNNN
Line 1: VVYYM
Line 2: NNNNN
Pump iFlow Module Addresses
Addresses on the iFlow module are factory set.
To Next Page
Loading...
