Repair
5-5
Part 1618871−01
2020 Nordson Corporation
Touchscreen Replacement
WARNING: Do not remove the touchscreen while power is ON. Remove
power from system or turn off the main power switch on main cabinet.
Failure to observe this warning could result in damage to the equipment or
personal injury.
CAUTION: Do not turn off cabinet power without first performing a program
shutdown. Doing so could corrupt the Engage program and operating
system on the program card.
NOTE: Gaskets are glued to the cabinet and remote display case around
the opening. Do not damage or remove these gaskets as that will destroy
the dust-tight integrity of the enclosure and void agency approvals.
1. Open main cabinet door or the remote display case.
2. See Figure 5-11. Note which IP address is checked on the IPS label (1)
on back of the current touchscreen for later use.
3. Disconnect the ground connection (2).
4. Disconnect Ethernet (3) and power harness connection (4).
Back View
1
2
Bottom View
3 4
1618656
Figure 5-11 Touchscreen IP Label and Connections
1. IPS label
2. Grounding connection
3. Ethernet 4. Power harness
To Next Page
Loading...
