Fulfill
Retrofit for Mesa Melters
25
Part 1121938_02
2013 Nordson Corporation
Assemble the Transfer Hose, Air Line, and Suction Lance
CAUTION! Allow for 10 in. bend radius for installation/use of the adhesive
transfer hose.
1. Using one hose clamp, attach the transfer hose (A) to the end of the
suction lance (B).
2. Insert the suction lance into the PVC pipe inside the adhesive storage
bin.
3. Use the remaining hose clamp to attach the transfer hose to the feed
system inlet tube (C). The hose should be routed without sharp bends or
kinks.
NOTE: If necessary, loosen the inlet tube retaining screws and then
reposition the inlet tube.
4. Connect the air line (D) to the suction lance air inlet (E).
5. Route the air line along the transfer hose, securing it with wire ties as you
go. The hose should be routed without sharp bends or kinks.
6. Leaving enough air line to reach the outlet (F) of the air solenoid, cut the
air line to length and then insert the end of the air line into the outlet.
7. Connect plant air to the regulator. For best results, run the air piping
from the main header.
B
A
C
D
E
F
Figure 13 Assembling the transfer hose, air line, and suction lance
To Next Page
Loading...
Need help?
General
