Nortel 7400 - Page 202

202 Chapter 38 Termination or sparing panel replacement
NN10600-175 6.1S2
Task flow navigation
The following references are listed alphabetically:
• “Installing a 13-inch termination panel on a Multiservice Switch 7420”
(page 235)
• “Installing a 13-inch termination panel on a Multiservice Switch 7440”
(page 238)
• “Installing a 19-inch rack-mounted termination panel” (page 240)
• “Installing a Multiservice Switch cabinet door” (page 291)
• “Installing FP cables” (page 349)
• “Re-enabling an LP”. See NN10600-550 Nortel Networks Multiservice
Switch 7400/15000/20000 Common Configuration Procedures.
• “Removing a 13-inch termination panel from a Multiservice
Switch 7420” (page 406)
• “Removing a 13-inch termination panel from a Multiservice
Switch 7440” (page 408)
• “Removing a 19-inch rack-mounted termination panel” (page 410)
• “Removing a cabinet door” (page 412)
• “Switching between active and standby processor cards”. See
NN10600-550 Nortel Networks Multiservice Switch 7400/15000/20000
Common Configuration Procedures.
• “Temporarily disabling an LP”. See NN10600-550 Nortel Networks
Multiservice Switch 7400/15000/20000 Common Configuration
Procedures.