Nortel 7400 - Page 48

48 Chapter 3 Multiservice Switch 7440 installation
NN10600-175 6.1S2
Figure 6
Multiservice Switch 7440 installation task flow: part 2
Task flow navigation
The following references are listed alphabetically:
• “FP addition” (page 151)
• “Grounding a dc-powered Multiservice Switch 7440” (page 227)
• “Installing a power supply into a Multiservice Switch 7440” (page 293)
• “Installing a 13-inch termination panel on a Multiservice Switch 7440”
(page 238)
• “Installing a control processor” (page 254)
• “Installing a floor-mounted Multiservice Switch 7440” (page 267)
• “Installing a Multiservice Switch 7440 into a rack or cabinet” (page 279)
• “Installing an ac power cable” (page 311)
• “Installing dc power cables onto a Multiservice Switch 7440” (page 337)
• “Installing ferrite beads onto dc power cables” (page 346)
• “Installing FP cables” (page 349)
• “Powering up a Multiservice Switch 7440” (page 394)
• “Unpacking a Multiservice Switch 7440” (page 530)
• “Unpacking a processor card” (page 539)
No
Yes
Add another
FP?
Powering up a
Multiservice
Switch 7440
A
End
FP
addition
PP_TASK_1011