3-2
Installation guidelines
AN2016 Cabinet User Guide Rel 1.0 Standard May 1999
Procedure 3-1
Unpacking the cabinet
Use this procedure to unpack the AN2016 Cabinet.
Requirements
You need the following tools and materials:
• claw hammer or ripping bar to remove crating material
Action
Step Action
1
Check the packing notes to confirm that you have all listed items. Report any
discrepancies immediately.
2
Inspect the shipping containers for possible damage during shipment. Report
any damage immediately for investigation and possible damage claims.
3
Carefully remove all packaging material from around the cabinet and pallet.
Note:
Keep the crating material to protect the cabinet during transfer to the
mounting site.
—end—
Risk of cabinet tipping
Before opening the front or rear door, ensure that
the other door is locked. Open both doors at the
same time only when the cabinet is secure on the
mounting pad.
CAUTION
Equipment damage
Take special care not to damage the paint finish of
the cabinet.
To Next Page
Loading...
