Nortel Modular ICS 4.0 - Turning on Line Redirection

88 / Forwarding your calls
Modular ICS 4.0 System Coordinator Guide P0881591 Issue 01
You cannot use the Line Redirection feature on either an
M7100 telephone or a telephone connected to an ATA.
Turning on Line Redirection
ƒ°›
1. Press ƒ°› .
2. Select the outgoing line to be used for redirected calls.
3. Enter the number to which calls are redirected (the ways
you can do this are listed below).
4. Select the lines to be redirected.
Enter the telephone number to which you want to redirect
calls, using one of the following methods:
• Press an external autodial button.
• Enter an external telephone number (using no more than
24 digits) then press ˙ or OK
.
• Press ˙ or OK if the line you have chosen as the
outgoing line is a private network line that does not require
you to dial digits.
If you use ALL
to redirect all your lines, it is important that you
wait until all the lines on your telephone light up before
pressing ˙ or OK
. If you press ˙ or OK
before all the lines light up, those lines not lit are not
redirected.
p0881591.book Page 88 Wednesday, August 19, 1998 6:43 PM