Nortel Modular ICS 4.0 - Canceling Line Redirection; Allowing a Telephone to Redirect Calls

Forwarding your calls / 89
P0881591 Issue 01 Modular ICS 4.0 System Coordinator Guide
Canceling Line Redirection
ƒ£°›
1. Press ƒ£°› .
2. Select the lines you no longer want to be redirected.
Allowing a telephone to redirect calls
You can turn a telephone’s ability to redirect calls on and off.
You need the programming template found at the front of this
guide. See “Getting started with Norstar” on page 1 for more
information.
1. Press ƒ••¤flfl‹›› .
2. Press ¤‹fl›fl (the default System Coordinator
password).
3. Press ≠ and enter the internal number of the
telephone you want to program.
4. Press ≠ twice.
5. Press “ four times. The display reads
Allow redirect:.
Tip - The line chosen for redirecting calls on other lines
can be used normally when it is not busy on a redirected
call. To avoid redirection failing because the chosen line is
in use, choose a line pool with several lines in it.
The system does not check that the number you give for
line redirection is a valid one. If you redirect to an invalid
number, redirection fails. Using an autodial button to enter
the redirection number helps avoid this possibility. An
autodial button used for line redirection must be
programmed to use a specific line.
p0881591.book Page 89 Wednesday, August 19, 1998 6:43 PM