128 / User Preferences
Modular ICS 4.0 System Coordinator Guide P0881591 Issue 01
telephone at the extension.
The display shows Connect set if no telephone is
connected at that internal number.
You cannot make changes if the model is Other.
3. Press
‘
to move through all the subheadings in
User Preferences.
User Preferences programming is available under the heading
User Prefernces in Terminals&Sets in the main body of
programming.
Sub-headings in User Preferences
Changing button programming
Press
≠
at Button prgrming. The display shows the
number of buttons on the telephone (an example is shown in
Displays at the end of this section).
If the telephone has a CAP module, you can press CAP1
to see
the buttons on the module.
Press
‘
to move through all the buttons on the
telephone.
User prefernces
Model
Button prgrming
User speed dial
Call log opt’ns
Dialing opt’ns
Language
Display cntrst
Ring type
p0881591.book Page 128 Wednesday, August 19, 1998 6:43 PM
To Next Page
Loading...
